Topic: Bt HomeHub 4 acces with Putty

The content of this topic has been archived on 25 Mar 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Page 1 of 1

Post #1

pohcho3

20 Feb 2018, 06:42

Hello Guys!

each time I start putty I get to below without shorting boot_sel2 with gnd.

ROM VER: 1.1.4
CFG 06
NAND
NAND Read OK

DDR autotuning Rev 0.3d
DDR size from 0xa0000000 - 0xa7ffffff
DDR check ok... start booting...

But it doesn't allow me to proceed any further from here. What i did is just connect hub to PC,and trying acces to it via Putty.Please help what i do wrong?

The discussion might have continued from here.

Page 1 of 1