The content of this topic has been archived on 4 May 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Hello,
I want to bridge 3G interface and LAN interface by LUCI. I have installed the packages below. However there is no "Relay Bridge" options on the LUCI interface list. Is there some missing packages ?
opkg install relayd
opkg install luci-proto-relay
Best Regards
https://www.nerd-quickies.net/wp-conten … bridge.png
(Last edited by enkavak on 20 Feb 2018, 19:38)
look this ( relayd run no problem with luci )
https://forum.openwrt.org/viewtopic.php … 47&p=2
add a new interfaces ( stabridge ) in luci
...
Hello,
I take a look at the link you provided. There is no "relay bridge" selection on the interfaces list. I manually modifed the "/etc/config/network" file like below. Nothing has changed. I still can not bridge between 3G and LAN
config 'interface' 'stabridge'
option 'proto' 'relay'
option 'network' 'lan 3g'
Luci ->
interfaces : add new interface -> stabridge
edit stabridge and look in the protocol configuration
you have many options : at top static adress ... at bottom you can find relay bridge
After you can tag options for make relay between networks
----------------------
look this for 3G <-> Wifi :
https://forum.openwrt.org/viewtopic.php?id=34859
(Last edited by F5BJR on 21 Feb 2018, 07:19)
Hello F5BJR
edit stabridge and look in the protocol configuration
you have many options : at top static adress ... at bottom you can find relay bridge
After you can tag options for make relay between networks
This is the problem I have. There is no "relay bridge" in the list that you mentioned.
What could be the missing ?
you have make : opkg install relayd luci-proto-relay , sure ?
(Last edited by F5BJR on 21 Feb 2018, 07:52)
Yes I am sure that I added "luci-proto-relay" to my new image. I also see it in the installed packages.
if you have installed relayd & luci-proto-relay so here I do not know, there is a problem somewhere
Is there any other luci package required ? In my research, the only required packages are relayd & luci-proto-relay.
I do not understant what is the problem.
Thanks for the link. However, I have already read the link. the link also says the packages I have already installed.
relayd & luci-proto-relay
What else ?
what box do you use ?
I installed the package "luci-proto-ipv6" and my problem is resolved. Now I can see the "Relay bridge" in the protocol list. However I can not share the 3G modem's internet to the ethernet. Can you share a configuration ?
Best Regards
The discussion might have continued from here.
