Hi ! i have problem with mw setup wireless mesh network, i use routing protocol batman-adv on my router and use openwrt as my firmware. my setup i have 4 router , and mesh network can connect . but in non user client can't connected, can anybody help me ?
Thanks
Topic: routing protocol batman-adv on OpenWrt
The content of this topic has been archived on 23 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
For ordinary devices to connect, you need to have a separate AP mode interface on the radio. This is usually bridged into the mesh or it can be routed.
@mk24 previously I've tried it, but it fails and the configuration gets messed up,
I use DD-Trunk on my router and use batman-adv 2017.03.
can you explain or give an example?
thanks you
The discussion might have continued from here.
Page 1 of 1