Topic: Add new button for firstboot

The content of this topic has been archived on 26 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Page 1 of 1

Post #1

cezane

3 Apr 2018, 21:25

Hi there,

I was unable to recon the place where should I add a new hardware button. There is a lot of documentation on how to configure a known button (like BTN_1) but I was unable to find where could I define a new GPIO pin.

I'm using a LinkIt Smart distribution (CC 15.05) on MT7688, and I want to define a GPIO (say 15) to behave as failsafe/firstboot if I'm holding it for 10 seconds while booting.

Where should I configure this? Thanks in advance!

Thanks,
Cezane

The discussion might have continued from here.

Page 1 of 1