Hello,
I'd like to know if someone can please help me or do it itself to port the OneWireFileSystem into buildroot-ng. It's hard for me to understand the whole makefile making thingy in this case. The old files are located here:
http://home.mag.cx/openwrt/source/mk/package/owfs/

I'd also like to ask if someone can tell me, how to implement an option in package configuration that is not threestated, but can take integer values (like in some kernel sound card drivers for IRQ etc.)?

Thanks in advance,
olg

I have updated the makefiles to compile the latest owfs-version 2.5p10, but I haven't tested it for the kamiaze build.
Same url as you wrote...

/Christian

Hm, but on the  kamikaze buildroot(ng) it does not compile..

olg@E ~/openwrt/trunk $ nice make V=99
make[1]: Entering directory `/home/olg/openwrt/trunk/scripts/config'
make[1]: `conf' is up to date.
make[1]: Leaving directory `/home/olg/openwrt/trunk/scripts/config'
Collecting package info: package/owfsMakefile:30: /home/olg/openwrt/trunk/package/rules.mk: No such file or directory

It think there are only minor changes nesessary, but I don't know how it could be done. I've also looked at some other Makefiles, maybe with some trial-and-error...
But it would be nice, if you or someone, with more knowlege in this makefile topic than I, could port this to Kamikaze.

Another question:
How is best way to implement an GPIO-bitbanging driver? Rewrite the  ow_ds9097.c or create a whole new adapter?
I like to use owfs without a spare UART on my device, like on the AR5315. Also the whole soldering would be reduced to one resistor between data and ground.

bye,
olg

OWFS-packages for kamikaze could be found at:
http://owfs.sourceforge.net/openwrt/kamikaze/packages

or
http://owfs.sourceforge.net/openwrt/kam … 6/packages

depending on which kernel you use... They are tested on a WRT54G router only.

Makefiles could be downloaded from this url... I think it's the latest makefiles I used...
http://home.mag.cx/openwrt/source/mk/ka … kage/owfs/

/Christian