who can help to make Redboot for a Netgear a WAG102?


CPU: AR5312A

FLash:    MX 29LV320CBTC-70G at 0x1e000000
http://www.alldatasheet.com/view.jsp?Se … 20CBTC-70G

NET:    RTL8201CP
http://www.realtek.com.tw/products/prod … ;ProdID=27

RAM: EM639165TS-6G
http://www.alldatasheet.com/view.jsp?Se … EM639165TS

Board Configuration

###########original boot params ###############

[Boot]: p

boot device          : tffs:
unit number          : 0
processor number     : 0
file name            : /fl/wag102
inet on ethernet (e) : 192.168.0.232:0xffffff00
flags (f)            : 0x0
other (o)            : ae

#########################################

name:     AP AR5001AP default
magic:    35333131
cksum:    1699
rev:      4
major:    1
minor:    0
pciid:    0013
wlan0:    yes 00:18:4d:07:b0:20
wlan1:    yes 00:18:4d:07:b0:21
enet0:    yes 00:18:4d:07:b0:20
enet1:    no  34:12:78:12:11:77
uart0:    yes
sysled:   yes, gpio 7
factory:  yes, gpio 6
serclk:   internal
cpufreq:  calculated 220000000 Hz
sysfreq:  calculated 55000000 Hz
memcap:   disabled
watchdg:  enabled

########## Boot Menu########################
[Boot]: ?

?                     - print this list
@                     - boot (load and go)
p                     - print boot params
c                     - change boot params
e                     - print fatal exception
v                     - print version
B                     - change board data
S                     - show board data
n netif               - print network interface device address
$dev(0,procnum)host:/file h=# e=# b=# g=# u=usr [pw=passwd] f=#
                           tn=targetname s=script o=other
boot device: tffs=drive,removable     file name: /tffs0/vxWorks
Boot flags:           
   0x02  - load local system symbols
   0x04  - don't autoboot
   0x08  - quick autoboot (no countdown)
   0x20  - disable login security
   0x40  - use bootp to get boot parameters
   0x80  - use tftp to get boot image
   0x100 - use proxy arp

available boot devices:Enhanced Network Devices
ae0 tffs



###########tftp boot params ###############

[Boot]: p

boot device          : ae
unit number          : 0
processor number     : 0
host name            : tftpserver
file name            : bootfile
inet on ethernet (e) : 192.168.1.232:0xffffff00
inet on backplane (b): 192.168.1.20
host inet (h)        : 192.168.1.10
flags (f)            : 0x80
startup script (s)   : factory
other (o)            : ae

################################################



Bootlog from KAMIKAZE RAM Boot Image
auto-booting...

Attached TCP/IP interface to ae0.
Attaching network interface lo0... done.
Loading... 3805216
Linux version 2.6.19.2 (krieg@hk-linux) (gcc version 4.1.1) #2 Wed Feb 7 21:32:16 CET 2007
CPU revision is: 00018009
Determined physical RAM map:
memory: 01000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Built 1 zonelists.  Total pages: 4064
Kernel command line: console=ttyS0,9600 rootfstype=squashfs,jffs2
Primary instruction cache 16kB, physically tagged, 4-way, linesize 16 bytes.
Primary data cache 16kB, 4-way, linesize 16 bytes.
Synthesized TLB refill handler (19 instructions).
Synthesized TLB load handler fastpath (31 instructions).
Synthesized TLB store handler fastpath (31 instructions).
Synthesized TLB modify handler fastpath (30 instructions).
PID hash table entries: 64 (order: 6, 256 bytes)
Using 110.000 MHz high precision timer.
Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
Memory: 12256k/16384k available (1925k kernel code, 4128k reserved, 274k data, 1416k init, 0k highmem)
Mount-cache hash table entries: 512
Checking for 'wait' instruction...  available.
NET: Registered protocol family 16
Radio config found at offset 0x10000
Algorithmics/MIPS FPU Emulator v1.5
NET: Registered protocol family 2
IP route cache hash table entries: 128 (order: -3, 512 bytes)
TCP established hash table entries: 512 (order: -1, 2048 bytes)
TCP bind hash table entries: 256 (order: -2, 1024 bytes)
TCP: Hash tables configured (established 512 bind 256)
TCP reno registered
squashfs: version 3.0 (2006/03/15) Phillip Lougher
devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
JFFS2 version 2.2. (NAND) (C) 2001-2006 Red Hat, Inc.
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver $Revision: 1.90 $ 1 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0xbc000003 (irq = 37) is a 16550A
eth0: Dropping NETIF_F_SG since no checksum feature.
eth0: Atheros AR2313: 00:18:4d:07:b0:20, irq 3
physmap platform flash device: 00400000 at 1e000000
physmap-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank
Amd/Fujitsu Extended Query Table at 0x0040
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
cmdlinepart partition parsing not available
Searching for RedBoot partition table in physmap-flash.0 at offset 0x3d0000
Searching for RedBoot partition table in physmap-flash.0 at offset 0x3e0000
Searching for RedBoot partition table in physmap-flash.0 at offset 0x3f0000
No RedBoot partition table detected in physmap-flash.0
ip_conntrack version 2.4 (128 buckets, 1024 max) - 240 bytes per conntrack
ip_tables: (C) 2000-2006 Netfilter Core Team
eth0: Configuring MAC for full duplex
TCP vegas registered
NET: Registered protocol family 1
NET: Registered protocol family 17
Bridge firewalling registered
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
Time: MIPS clocksource has been installed.
Freeing unused kernel memory: 1416k freed
Warning: unable to open an initial console.

init started:  BusyBox v1.4.1 (2007-02-07 20:22:14 CET) multi-call binary
PPP generic driver version 2.4.2

Please press Enter to activate this console. wlan: 0.8.4.2 (0.9.2.1)
ath_hal: module license 'Proprietary' taints kernel.
ath_hal: 0.9.17.2 (AR5212, AR5312, RF2316, TX_DESC_SWAP)
ath_rate_sample: 1.2 (0.9.2.1)
wlan: mac acl policy registered
ath_ahb: 0.9.4.5 (0.9.2.1)
wifi%d: unable to attach hardware: 'Hardware revision not supported' (HAL status 13)
wifi%d: unable to attach hardware: 'Hardware revision not supported' (HAL status 13)
: /sbin/wifi: eval: 1: Syntax error: Bad substitution

sysctl: error: 'net.ipv4.tcp_syncookies' is an unknown key

sysctl: error: 'net.ipv4.ip_conntrack_tcp_timeouts' is an unknown key

sysctl: error: 'net.ipv4.ip_conntrack_udp_timeouts' is an unknown key




BusyBox v1.4.1 (2007-02-07 20:22:14 CET) Built-in shell (ash)
Enter 'help' for a list of built-in commands.

  _______                     ________        __
|       |.-----.-----.-----.|  |  |  |.----.|  |_
|   -   ||  _  |  -__|     ||  |  |  ||   _||   _|
|_______||   __|_____|__|__||________||__|  |____|
          |__| W I R E L E S S   F R E E D O M
KAMIKAZE (bleeding edge, r6274) -------------------
  * 10 oz Vodka       Shake well with ice and strain
  * 10 oz Triple sec  mixture into 10 shot glasses.
  * 10 oz lime juice  Salute!
---------------------------------------------------
root@OpenWrt:/#


   
Thanks
Holger