OpenWrt Forum Archive

Topic: TP-Link TL-WR800N v1.0

The content of this topic has been archived between 29 Apr 2018 and 30 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Sent! I will find a place to share them...

可以把做好的固件上传到网盘吗?
Can you upload the firmware to network drive?
I can some simple english.

Did anybody get WR800N to work with OpenWrt?

catiome wrote:

I found custom U-Boot for WR800N.  I'm going to flash it to device. After that I'm going flash some openwrt firmware for same atheros-cpu-based-router.


Hoping you will share if you successfully changed the bootloader and firmware for the TP-Link TL-WR800N.

Thanks!

Soldered a 16M ROM and a 64M RAM chip on it. Then flashed with official lede-17.01.4-ar71xx-generic-tl-wr841-v8-squashfs-factory.bin. Works like a charm. Reset button not tested yet (GPIO #18) and may not work. Default network port is LAN. You will need to play with VLAN for WAN

The discussion might have continued from here.